Table of Contents
Advertisement
1
Remove any paper clips and staples before loading a document.
2
Adjust the movable document guides to
match the size of the document to be loaded.
Note
3
Place the document (the front side of 2-sided
document) face up in the center of the
document feeder.
Note
Document Glass
The document glass supports a single sheet, a book, or other similar documents from
15 x 15 mm up to 297 x 432 mm (A3, 11 x 17").
Important • Always close the document cover after using the document glass.
The document glass automatically detects standard size documents. For non-standard
size documents, enter the size on the [Original Size] screen.
For information on document sizes that can be detected automatically, or how to enter variable sizes,
refer to "Original Size (Specifying a Scan Size)" (P.165).
The standard document sizes that can be detected automatically depend on the [Paper Size Settings] in
the System Administration mode. For information on the paper size settings, refer to "5 Tools" >
"Common Service Settings" > "Other Settings" > "Paper Size Settings" in the Administrator Guide.
CAUTION
Do not apply excessive force to hold thick document on the document glass. It may
break the glass and cause injuries.
1
Open the document cover.
Important • Ensure that the touch screen is active,
• When loading a large document such as
A3, open the document stopper
rightward.
• The Confirmation indicator lights up when
the document is loaded correctly.
• When the document is loaded in the
document feeder, the document feeder
tray lifts up. The timing of the lift can be
programmed in [System Settings]. For
more information, refer to "5 Tools" >
"Common Service Settings" > "Other
Settings" > "Document Feeder Tray
Elevation" in the Administrator Guide.
and then load a document. Otherwise, the
machine may not properly detect the
document size.
Scanning Procedure
Document stopper
Confirmation indicator
4
149
Advertisement
Table of Contents
