Figure 1.14 Controller (Sas Model) - Fujitsu ETERNUS DX60 S2 User Manual

Chapter 1 Components
1.1 Controller Enclosure
UNIT READY/
FAULT
MASTER
ACT
LINK
FAULT
■
SAS model

Figure 1.14 Controller (SAS model)

●
Part explanation
• LAN (RMT) port, LAN (MNT) port
These are the RJ-45 connectors to connect LAN cables. LAN (RMT) port is not used in the
EMEA&I region.
A single controller has one LAN (RMT) port and one LAN (MNT) port.
• SAS port (0 (left), 1 (right))
These are the miniSAS (SFF8088) connectors to connect miniSAS cables.
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
LED name LED status
(green)
(orange)
(green)
(green)
(green)
(orange)
SCU STATUS LED
IDENTIFY LED
DI (OUT) LINKUP LED
LAN (RMT) port
LAN (MNT) port
ACT LED
LINK LED
DI (OUT) port
Copyright 2013 FUJITSU LIMITED
The controller is in normal status.
•
The controller is performing the initial setup after the
power is turned on.
•
The controller is in error status.
The controller is set as a Master CM.
The controller is sending or receiving data via the LAN
port (for operation management).
•
The link between the LAN port (for operation
management) and the destination has been
established.
•
The link between the iSCSI port (host interface port)
and the destination has been established.
•
The controller is performing the initial setup after the
power is turned on.
•
The iSCSI port (host interface port) is in error status.
SAS (HOST) LINKUP/FAULT LED
SAS port (0 (Left), 1 (Right))
UNIT READY/FAULT LED
MASTER LED
PWC port
20
Controller status
P3AM-5512-05ENZ0