Oil And Filter Replacement - Hyundai Seasall S250S Workshop Manual

Engine Mechanical System
Replacement
Oil and Filter
◉ CAUTION
• Prolonged and repeated contact with mineral oil will
result in the removal of natural fats from the skin,
leading to dryness, irritation and dermatitis. In addition,
used engine oil contains potentially harmful
contaminants which may cause skin cancer.
• Exercise CAUTION in order to minimize the length
and frequency of contact of your skin to used oil. Wear
protective clothing and gloves. Wash your skin
thoroughly with soap and water, or use water-less hand
cleaner, to remove any used engine oil. Do not use
gasoline, thinners, or solvents.
• In order to preserve the environment, used oil and
used oil filter must be disposed of only at designated
disposal sites.
1. Remove the oil filter cap.
1) Using a wrench (32mm or equivalent), loosen the oil
filter cap slowly. Be careful not to drop engine oil
because the oil filter paper is removed with its cap at
this moment.
2. Remove the oil filter paper (A) and its O-ring (B) from
its cap
55
1) Remove the filter paper assembly (A).
2) Replace the filter paper assembly and O-ring (B) with
new ones and do not reuse the O-ring removed.
3. Assemble the oil filter cap with the filter fixed.
Tightening Torque:
24.5Nm (2.5kgf.m, 18.1lb-ft)
4. Opening the oil filler cap and removing the oil pan
drain plug, drain engine oil thoroughly.
5. Reassemble the drain plug with a new gasket. Do
not reuse the gasket removed.
Tightening Torque:
34.3 ~ 44.1Nm (3.5 ~ 4.5kgf.m, 25.3 ~ 32.5lb-ft)
6. Fill new engine oil through the oil filler pipe.
[Capacity]
When replacing a short engine or a block assembly:
7.3L (7.71US qt, 6.42lmp qts)
When replacing oil pan only:
5.8L (6.13US qt, 5.10lmp qts)
Drain and refill including oil filter:
6.8L (7.19US qt, 6.00lmp qt)
◉ CAUTION
• Fill a half oil of the total amount first and do the rest
again after about one minute later,
• Do not fill oil over the 'F' line, checking the level with
the oil level gauge.
7. Start engine and check for oil leaks.
8. Recheck the engine oil level
Lubrication System