Engine Oil Extaction Pump; Oil Filter Replacement - Hyundai Seasall S250S Installation & Operation Manual

INSTALLATION & OPERATION MANUAL
4. OIL EXTACTION PUMP
1) Allow the engine to warm up at least 5 minutes.
2) Remove the engine oil inlet cap and oil filter.
3) The oil drain hose is connected to the oil extraction pump ①, route the loose end of
the hose into the container being used for the oil change②.
4) Turn the ignition key on (but do NOT start the engine) then press and hold the button
③ on the side of the ECU box with the ignition switched on until the engine oil (about
7.2liters) is completely pumped out.

5. OIL FILTER REPLACEMENT

1) Remove the oil filter cap by using a 36mm wrench; loosen
the oil filter cap slowly. Be careful not to drop engine oil
while the oil filter paper is removed with its cap.
2) Remove the oil filter element (A) and its O-ring (B) from the
cap.
3) Replace the filter element assembly and O-ring with the
new ones that are supplied in the service kit. Do not reuse
the removed O-ring.
4) Assemble the oil filter cap with the filter fixed. The
tightening torque is 24.5Nm (2.5kgf·m, 18.1lb-ft).
!
!
USED OIL MUST BE STORED IN A SAFE PLACE AWAY FROM CHILDREN
USED OIL MUST BE STORED IN A SAFE PLACE AWAY FROM CHILDREN
AND SOURCES OF IGNITION. IF YOU HAVE A USED OIL DISPOSAL
AND SOURCES OF IGNITION. IF YOU HAVE A USED OIL DISPOSAL
PROBLEM, PLEASE HAVE THE ENGINE OIL CHANGED BY YOUR
PROBLEM, PLEASE HAVE THE ENGINE OIL CHANGED BY YOUR
NEAREST HYUNDAI SEASALL SERVICE DEALER.
NEAREST HYUNDAI SEASALL SERVICE DEALER.
S250 and S220 Series Engines
WARNING
- 34 -
WARNING