Main Bracket Assembly; Engine Timing System - Hyundai Seasall S250S Workshop Manual

Engine Mechanical System
Removal

Main Bracket Assembly

✍ NOTICE
Turn the ignition key switch to "OFF" position or
disconnect the battery cable while removing the bracket.
1. Remove the engine harness.
2. Remove bolts connected to support bracket.
Tightening Torque:
24.5 ~ 29.4Nm (2.5 ~ 3.0kgf.m, 18.1 ~ 21.7lb-ft)
3. Remove bolts connected to engine block.
Tightening Torque:
44.1 ~ 49.0Nm (4.5 ~5.0kgf.m, 32.5 ~ 36.2lb-ft)

Engine Timing System

1. Compressing the tensioner with a wrench in a left
hand by turning it clockwise, start removing the drive
belt from the water pump side idler.
✍ NOTICE
Conform to what is described above because tension of
the belt in this engine is higher than ones of other
engines for preventing a slip
22
2. Remove the drive belt tensioner(A).
3. Remove the power steering bracket.
4. Remove the water pump pulley (D).
5. Remove the drive belt idler(C).
6. Remove the alternator (B) with its bracket (A).
7. Remove the engine hanger.
8. Remove the water pump pulley bolt.
9. Remove the water pump pulley (A).
10. Remove the crankshaft pulley (A) with its washer
(B) and mounting bolt(C).
Timing System