Connector Inspection Procedure; Checking Point For Connector - Hyundai Seasall S250S Workshop Manual

Fuel System

Connector Inspection Procedure

1. Handling of Connector
a. Never pull on the wiring harness when
disconnecting connectors.
b. When removing the connector with a lock, press
or pull locking lever.
c. Listen for a click when locking connectors. This
sound indicates that they are securely locked
d. When a tester is used to check for continuity, or
to measure voltage, always insert tester probe
from wire harness side
94
e. Check waterproof connector terminals from the
connector side. Waterproof connectors cannot be
accessed from harness side
✍ NOTICE
• Use a fine wire to prevent damage to the
terminal.
• Do not damage the terminal when inserting the
tester lead.

2. Checking Point for Connector

a. While the connector is connected:
Hold the connector, check connecting condition
and locking efficiency.
b. When the connector is disconnected:
Check missed terminal, crimped terminal or
broken core wire by slightly pulling the wire
harness. Visually check for rust, contamination,
deformation and bend.
c. Check terminal tightening condition:
Insert a spare male terminal into a female
terminal, and then check terminal tightening
conditions.
d. Pull lightly on individual wires to ensure that each
wire is secured in the terminal.
General Information