Hyundai Seasall S250S Workshop Manual page 27

Engine Mechanical System
✍ NOTICE
Install it after removing sealant from the camshaft
bearing ladders.
15. Install the crankshaft pulley (A) with its washer (B)
and tighten the mounting bolt(C).
Tightening Torque:
186.3 ~ 205.9Nm (19 ~ 21kgf.m, 137.4 ~ 151.8lb-ft) +
58˚ ~ 62˚
✍ NOTICE
After removing the starter and installing the SST
(00200-0T007), tighten the crankshaft bolt
26
16.Install the drive belt idler(A).
Tightening Torque:
34.3 ~ 44.1Nm (3.5 ~ 4.5kgf.m, 25.3 ~ 32.5lb-ft)
17.Install the water pump(A).
Tightening Torque:
7.8 ~ 11.8Nm (0.8 ~ 1.2kgf.m, 5.8 ~ 8.7lb-ft)
18.Install the engine hanger.
Tightening Torque:
19.6 ~ 26.5Nm (2.0 ~ 2.7kgf.m, 14.5 ~ 19.5lb-ft)
19.Install the alternator(B) with its bracket(A).
Tightening Torque:
29.4 ~ 41.2Nm (3.0 ~ 4.2kgf.m, 21.7 ~ 30.4lb-ft)
alternator
19.6 ~ 26.5Nm (2.0 ~ 2.7kgf.m, 14.5 ~ 19.5lb-ft) bracket
Timing System