Engine Oil Extaction Pump Engine Oil Extaction Pump; Oil Filter Replacement - Hyundai Seasall U125S Installation & Operation Manual

INSTALLATION & OPERATION MANUAL
ENGINE OIL EXTACTION PUMP
• Allow the engine to warm up at least 5 minutes.
• Remove the engine oil inlet cap and oil filter.
• The oil drain hose is connected to the oil extraction pump ①, route the loose end of the
hose into the container being used for the oil change②.
• Turn the ignition key on (but do NOT start the engine) then press and hold the button ③
on the side of the ECU box with the ignition switched on until the engine oil
(about 6 liters) is completely pumped out.

OIL FILTER REPLACEMENT

• Remove the oil filter (A) with the oil filter wrench.
• Inspect the threads and O-ring to apply a light coat engine
oil onto the new filter. Wipe off the seat.
• Install the new oil filter by hand.
• After the packing seats, tighten the oil filter clockwise
with the oil filter wrench. (2.3 ~ 2.5kgf·m / 24.5 Nm)
• Complete the reassembly and start the Engine. Then
check for oil leakage.
• Turn off the engine and check the oil level. Add oil if
necessary.
! ! ! !
USED OIL MUST BE STORED IN A SAFE PLACE AWAY FROM CHILDREN USED OIL MUST BE STORED IN A SAFE PLACE AWAY FROM CHILDREN
AND SOURCES OF IGNITION. IF YOU HAVE A USED OIL DISPOSAL AND SOURCES OF IGNITION. IF YOU HAVE A USED OIL DISPOSAL AND SOURCES OF IGNITION. IF YOU HAVE A USED OIL DISPOSAL AND SOURCES OF IGNITION. IF YOU HAVE A USED OIL DISPOSAL
PROBLEM, PLEASE HAVE THE ENGINE OIL CHANGED BY YOUR PROBLEM, PLEASE HAVE THE ENGINE OIL CHANGED BY YOUR
NEAREST HYUNDAI SEASALL SERVICE DEALER. NEAREST HYUNDAI SEASALL SERVICE DEALER.
U125 Series Engines
2
1
WARNING WARNING
-35-
3
A