Engine Oil Extaction Pump - Hyundai Seasall U125S Installation & Operation Manual

INSTALLATION & OPERATION MANUAL

ENGINE OIL EXTACTION PUMP

• Allow the engine to warm up at least 5 minutes.
• Remove the engine oil inlet cap and oil filter.
• The oil drain hose is connected to the oil extraction pump ①, route the loose end of the
hose into the container being used for the oil change②.
• Turn the ignition key on (but do NOT start the engine) then press and hold the button ③
on the side of the ECU box with the ignition switched on until the engine oil
(about 5.7 liters) is completely pumped out.
OIL FILTER REPLACEMENT
• Remove the oil filter (A) with the oil filter wrench.
• Inspect the threads and O-ring to apply a light coat engine
oil onto the new filter. Wipe off the seat.
• Install the new oil filter by hand.
• After the packing seats, tighten the oil filter clockwise
with the oil filter wrench. (2.3 ~ 2.5kgf·m / 24.5 Nm)
• Complete the reassembly and start the Engine. Then
check for oil leakage.
• Turn off the engine and check the oil level. Add oil if
necessary.
USED OIL MUST BE STORED IN A SAFE PLACE AWAY FROM CHILDREN
AND SOURCES OF IGNITION. IF YOU HAVE A USED OIL DISPOSAL
PROBLEM, PLEASE HAVE THE ENGINE OIL CHANGED BY YOUR
NEAREST HYUNDAI SEASALL SERVICE DEALER.
U125 Series Engines
WARNING
-34-
A