Hyundai Seasall S250S Workshop Manual page 64

Engine Mechanical System
14. Remove the inlet lower manifold assembly(A).
◉ CAUTION
The inlet lower manifold assembly (A) is the assembly
including the swirl control actuator (B).
Do NOT disassemble the swirl control actuator from
the inlet lower manifold.
Disassembly and reassembly may change the setting
specification of the two link shafts which are
connected between the inlet lower manifold and the
swirl control actuator.
17. Remove the inlet manifold gaskets(A).
63
Installation
1. Install the inlet manifold gaskets(A).
2. Install the inlet lower manifold assembly(A).
◉ CAUTION
The inlet lower manifold assembly (A) is the assembly
including the swirl control actuator (B).
If you have already disassembled the swirl control
actuator from the inlet lower manifold, you should
throw them away and install a new inlet lower
manifold assembly including the swirl control actuator.
Disassembly and reassembly may change the setting
specification of the two link shafts which are
connected between the inlet lower manifold and the
swirl control actuator.
Tightening Torque:
9.8 ~ 11.8Nm (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)
3. Install the blow-by gas recirculation system such as
the oil separator pipes and hoses.
Intake and Exhaust System