Engine Mechanical System
10) If the plastic gauge shows the clearance is still
incorrect, try the larger or smaller bearing. Recheck the
oil clearance.
✍ NOTICE
If the proper clearance still cannot be obtained after
using the appropriate larger or smaller bearings,
replace the crankshaft and restart measuring
◉ CAUTION
If the marks are indecipherable because of an
accumulation of dirt or dust, do not scrub them with a
wire brush or scraper. Clean them only with solvent or
detergent.
Connecting rod mark location
Discrimination Of Connecting Rod
Crankshaft pin journal mark location
41
Discrimination Of Crankshaft Pin Journal
Connecting Rod Bearing Mark Location
Discrimination Of Connecting Rod Upper Bearing
Discrimination of connecting rod lower bearing
11) Select the suitable bearing by using the selection
table below.
Connecting Rod Bearing Selection Table
Cylinder block