Amature - Hyundai Seasall S250S Workshop Manual

Engine Electrical System
Replacement
1. Disconnect the starter motor cable(A) from the B
terminal of the solenoid and the connector
(B)from the S terminal.
2. Remove the starter by loosening the starter
mounting bolts(A).
3. Installation is in the reverse order of remove

Amature

1. Remove the starter.
2. Disassemble the starter as shown at the beginning of
this procedure.
3. Inspect the armature for wear or damage from
contact with the permanent magnet. If there is wear
or damage, replace the armature.
80
4. Check the commutator(A) surface. If the surface is
dirty or burnt, resurface with emery cloth or a lathe
within the following specifications, or recondition with
#500 or #600 sandpaper(B).
5. Check the commutator diameter. If the diameter is
below the service limit, replace the armature.
------------------------------------
Standard (New) : 30.0 mm (1.1811 in)
Service limit : 29.2 mm (1.1496 in)
------------------------------------
6. Measure the commutator(A) runout.
• If the commutator runout is within the service
limit, check the commutator for carbon dust or
brass chips between the segments.
Starting System