Installing In Vehicle - Infasecure CS4010 Instructions Manual

Place the child restraint on the vehicle seat. Ensure
Step 1:
recline section is swung forward and the restraint is
fully reclined with the restraint directly in line with
anchorage point.
Step 2:
Make sure upper anchorage strap is as in illustration
(Figures 1 and 2) i.e. positioned around restraint
back.
!
Ensure that you use the
BELT PATH
Step 3:
Feed adult lap or lap/sash belt through the belt path
opening, ensure the seat belt is under the cover &
between the layer of foam and the plastic seat base.
Engage the buckle and tongue assembly (listen for a
"CLICK"). Check the buckle engagement with a
gentle pull.
!
DO NOT USE REAR FACING CHILD RESTRAINT WHERE AN AIRBAG IS FITTED IN
FRONT OF THE SEATING POSITION.
Fit the restraint firmly to the car seat.
THIS TETHER STRAP MUST ALWAYS BE FITTED WHEN THE CHILD RESTRAINT IS
USED IN A VEHICLE.
INSTALLATION

INSTALLING IN VEHICLE

IMPORTANT
REARWARD-FACING
indicators, marked in "blue".
Recline Section (Swung Forward)
& child restraint fully reclined.
WARNING
Upper
Anchorage
Strap
Safe Grip
(red belt clamp)
Buckle & Tongue
Assembly
Lap Belt &
Sash Belt Passes
Through Here
14
Adjuster
Lap Belt
& Sash Belt
Figure 1
Front
of Car
Recline Section
Figure 2