MODELS Folding Booster Seat SUITABILITY OF THE CHILD RESTRAINT The CS6010 Booster Seat is suitable for toddlers to older children as a booster seat. BOOSTER SEAT (Type E Forward Facing) To be used with a lap-sash seat belt by children whose shoulders are above the lower shoulder height marker (approximately 4 years of age) until their shoulders reach the upper shoulder height marker (approximately 6 to 8 years of age) Continue to use this child restraint until the child reaches this limit.
Research has shown that the likelihood of an accessory child safety harness being used incorrectly is very high and the risk of injuries when incorrectly used is much higher compared to a lap-sash seat belt. InfaSecure recommend that an accessory child safety harness should only be used if a lap-only seat belt is all that is available.
MODEL CS6010 COMFORT COVER HEADREST A - SEAT BASE VEHICLE SEAT BELT B - BACKREST “BOOSTER SEAT BELT PATH” MARKER ARM REST (EACH SIDE OF THE RESTRAINT) (EACH SIDE OF RESTRAINT - COLOURED RED) SHOULDER HEIGHT MARKER...
SHOULDER HEIGHT MARKER SMALLER CHILD Front of Car LOWER LABEL Smaller Child from approximately 4 years of age Do not use this booster seat if the child’s shoulders are below the lower shoulder height marker, (Lower label) LOWER LABEL SHOULDERS MUST BE ABOVE THIS LINE IMPORTANT If moving a child from forward facing child restraint with an inbuilt harness, the child’s...
Page 7
SHOULDER HEIGHT MARKER TALLER CHILD CHILD’S SHOULDERS MUST BE BETWEEN THESE LINES UPPER LABEL Front of Car LOWER LABEL Taller Child up to approximated 8 years of age Continue to use this booster seat until the child’s shoulders reach the upper shoulder height marker, (Upper Label).
Unfold the booster seat and place the booster in the car in a forward facing position (refer Figure 1 & 2). USING LAP-SASH SEAT BELT the backrest. IMPORTANT BOOSTER SEAT Ensure that you use the BELT PATH indicators, marked in “red”. Position the lap section of the vehicle seat across the child’s lap then insert the buckle tongue in the belt buckle (A).
USING LAP-SASH SEAT BELT Remove the seat belt slack by first pulling on the lap belt in the direction of arrow 1 (refer figure 1) then pull the sash belt in the direction of arrow 2. Ensuring the lap portion is positioned under the armrests and over the child’s thighs.
Page 10
Seat belt extenders should not be used if the seat belt is not long enough. The CS6010 Booster Seat cover has been manufactured to meet the Australian Standards requirements for flammability and toxicity to ensure your child's safety. The cover has also been designed to provide...
Page 11
Ensure you have correctly reattached all elastic loops & hooks. IMPORTANT Use only mild soap and water to clean all parts of the CS6010 Child Seat. Do not use chemicals or cleaning agents Cold water only to be used and to be rinsed well Do not dry clean or tumble dry Do not bleach.
InfaSecure Warranty Details InfaSecure Pty Ltd warrants this product for twelve months from the date of purchase against failure due to manufacturing faults or faulty materials. Misuse, accidental damages, normal wear and tear or defect are not covered by this warranty.
Need help?
Do you have a question about the CS6010 and is the answer not in the manual?
Questions and answers