Advertisement

CS7110
CS7210
MODELS
Convertible Booster Seat
CHILD SEAT TO BOOSTER SEAT
(Forward Facing)
Suitable for children
from approximately
6 months to 4
years* of age
Suitable for children
approximately
4 to 8 years* of age
S I X M O N T H S T O E I G H T Y E A R S*
S I X M O N
6
m th
m
mth.
T R AV E L L I N G S
T R AV E L L I N G S A F E L Y W I T H P E A C E O F M I N D
The photo displayed is indicative of the
type of restraint and may vary slightly
depending on the model.
IMPORTANT
!
*All references to age are to an average proportioned
child. Children vary in shapes and sizes. The ages
outlined above is an approximation only.
T Y E A R S
8
t o
y rs.
y
yrs.
E A C E O F M I N D
1754:2010
Licence No. 25324

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CS7110 and is the answer not in the manual?

Questions and answers

Summary of Contents for Infasecure CS7110

  • Page 1 CS7110 S I X M O N T H S T O E I G H T Y E A R S* S I X M O N T Y E A R S CS7210 mth. m th yrs. y rs.
  • Page 2: Suitability Of The Child Restraint

    CS7210 MODELS SUITABILITY OF THE CHILD RESTRAINT TO GROUPS OF CHILDREN The CS7110/CS7210 Convertible Car Seat is suitable for toddlers and older children as a convertible booster seat. CONVERTIBLE BOOSTER SEAT (Type B and Type E) Child Seat to Booster Seat...
  • Page 3: Table Of Contents

    Restraint Guide Page 5 Padding - Combination Guide Page 6 - Information & Warnings Page 7 - CS7110/CS7210 Child Restraints (Itemised list) Page 8 - Shoulder Height Marker Page 9-10 SET UP - Selection of Appropriate Padding Combination Page 11...
  • Page 4 If so ring InfaSecure on (Aust) (02) 4728 8080 for Straps may be damaged by unsecured cargo nearest supply location. in a collision. Secure or remove hazardous ADDITIONAL EXTENSION STRAPS AVAILABLE: cargo before using this restraint.
  • Page 5: For Cars Not Fitted With Anchorage Points

    FOR CARS NOT FITTED WITH A CHILD RESTRAINT ANCHORAGE POINT UPPER ANCHORAGE FITTINGS FOR SEDANS ONLY Attachment Bolt WARNING SIDE VIEW...
  • Page 6: Restraint Guide

    Research has shown that the likelihood of an accessory child safety harness being used incorrectly is very high and the risk of injuries when incorrectly used is much higher compared to a lap-sash seat belt. InfaSecure recommend that an accessory child safety harness should only be used if a lap-only seat belt is all that is available.
  • Page 7: Padding - Combination Guide

    PADDING/INSERTS COMBINATION GUIDE STANDARD DELUXE MODE (Shoulder pads & buckle pads) CHILD SEAT (Small Child) FORWARD FACING CHILD SEAT (Large Child) FORWARD FACING BOOSTER SEAT FORWARD FACING The Padded Insert/s (if fitted) are designed to provide extra support and comfort for small babies.
  • Page 8: Information & Warnings

    CHILD SEAT CHILD SEAT (Forward Facing - using inbuilt harness) INFORMATION & WARNINGS To be used only in a forward-facing position with built-in harness by children whose shoulders are above the lower shoulder height marker (approximately 6 months of age) until their shoulders reach the middle shoulder height marker (approximately 4 years of age).
  • Page 9: Cs7110/Cs7210 Child Restraints (Itemised List)

    MODEL CS7110/CS7210 SHOULDER HEIGHT MARKER UPPER ANCHORAGE STRAP ASSEMBLY HARNESS SHOULDER STRAPS UPPER ANCHORAGE STRAP ADJUSTER BUCKLE ASSEMBLY ATTACHMENT CLIP HARNESS ADJUSTER ANCHOR FITTING + ATTACHMENT HARDWARE HARNESS ADJUSTMENT STRAP SAFE GRIP RED BELT CLAMP (supplied in pocket) 14. SHOULDER PADS VEHICLE SEAT BELT 15.
  • Page 10: Shoulder Height Marker

    SHOULDER HEIGHT MARKER SHOULDER HEIGHT MARKER SMALLER TODDLER (Using Inbuilt Harness) Shoulder height markers are provided on this restraint for a visual indication that the child is safe to travel in this restraint. Shoulder height markers may be hidden under a pillow in the lowest position. Front of Car LOWER...
  • Page 11 SHOULDER HEIGHT MARKER SHOULDER HEIGHT MARKER TALLER TODDLER (Using Inbuilt Harness) Shoulder height markers may be hidden under a pillow in the lowest position Front of Car MIDDLE MIDDLE LABEL LABEL Taller Toddler Up to approximately 4 years of age Continue to use this forward-facing child restraint until the child’s shoulders reach the middle shoulder height marker, (Middle Label) MIDDLE LABEL (Forward Facing)
  • Page 12: Selection Of Appropriate Padding Combination

    SELECTION OF APPROPRIATE PADDING COMBINATIONS Determine whether your child requires the additional padding provided with this restraint, to ensure a safe and snug fit in the restraint. Refer to page 6 for suggested padding combinations. ADJUSTING RECLINE ANGLE Determine which seat angle is prefered for the comfort of your child.
  • Page 13 SHOULDER SLOT HEIGHT Step 4: Thread each shoulder harness strap back onto the “G” connecting plate through the gate (see Figure 3). The shoulder harness straps are connected to the “G” connecting plate (see Figure 2). IMPORTANT Do not use the restraint with harness shoulder straps set at different heights.
  • Page 14 (Using Lap-sash Seat Belt) Hook the attachment clip to the anchor fitting. Ensure PULL TO Figure 2 ATTACH there are no twists in the upper anchorage strap TIGHTEN (Refer to Figure 2). Pull to tighten to remove all the slack, from the upper anchorage strap.
  • Page 15: Installation

    INSTALLATION (Using Lap-sash Seat Belt) Step 6: Push down on the base of the restraint (with knee or Figure 5 hand) whilst pulling the sash section of the vehicle belt firmly up in direction of the yellow arrow in figure Pull sash section up 5.
  • Page 16: Use

    USING IN-BUILT HARNESS Step 1: Ensure the restraint has been installed and set up as per “Set Up” and “Installation” (Refer page 10 - 13) PULL TO PULL TO Step 2: “LIFT” the harness adjuster (A) to lengthen the LENGTHEN LENGTHEN harness (see figure 1) whilst grasping both shoulder harness straps and pulling.
  • Page 17: Information & Warnings

    BOOSTER SEAT BOOSTER SEAT (Forward Facing - using lap-sash seat belt) INFORMATION & WARNINGS To be used with a lap-sash seat belt until the child’s shoulders reach the upper shoulder height marker (approximately 6 to 8 years of age) Continue to use this child restraint until the child reaches this limit. Children are safest in a booster seat until their shoulders reach the upper shoulder height marker of the booster seat.
  • Page 18: Shoulder Height Marker

    SHOULDER HEIGHT MARKER SMALLER CHILD (Using Lap-Sash Seat Belt) Shoulder height markers are provided on this restraint for a visual indication that the child is safe to travel in this restraint. Shoulder height markers may be hidden under a pillow in the lowest position. Front of Car MIDDLE...
  • Page 19 SHOULDER HEIGHT MARKER TALLER CHILD (Using Lap-Sash Seat Belt) Shoulder height markers may be hidden under a pillow in the lowest position UPPER UPPER LABEL LABEL Front of Car Taller Child up to approximated 6 to 8 years of age Continue to use this booster child restraint until the child’s shoulders reach the upper shoulder height marker, (Upper Label) UPPER LABEL (Forward Facing)
  • Page 20: Cs7110/Cs7210 Child Restraints (Itemised List)

    CS7110/CS7210 UPPER ANCHORAGE STRAP ASSEMBLY COMFORT COVER A - SEAT BASE UPPER ANCHORAGE STRAP ADJUSTER B - BACKREST ATTACHMENT CLIP SHOULDER HEIGHT MARKER ANCHOR FITTING + ATTACHMENT HARDWARE SAFE GRIP RED BELT CLAMP (SUPPLIED IN POCKET) VEHICLE SEAT BELT “BOOSTER SEAT BELT PATH” MARKER...
  • Page 21: Set Up

    SET UP SELECTION OF APPROPRIATE PADDING COMBINATIONS Determine whether your child requires the additional padding provided with this restraint, to ensure a safe and snug fit in the restraint. Refer to page 10 for suggested padding combinations. CONVERTING TO A CHILD BOOSTER IMPORTANT Figure 1 FOR USE OF THIS RESTRAINT AS A BOOSTER...
  • Page 22 ADJUSTING RECLINE ANGLE Determine which angle is prefered for the comfort of your child. TO RECLINE Pull down the recline base and ensure the UPRIGHT RECLINE support is forward (in position). Place the child restraint in the car, in a forward facing seating position (Refer to Figure 1) Install the upper anchorage fitting as shown on page 3 &...
  • Page 23: Installing In Vehicle

    USING LAP-SASH SEAT BELT WARNING DO NOT USE WITH JUST A LAP BELT. You must use a lap-sash seat belt. “INSTALLING IN VEHICLE” (refer page 20). the backrest. Position the lap section of the vehicle seat across the child’s lap then insert the buckle tongue in the belt buckle (A).
  • Page 24 USING LAP-SASH SEAT BELT WARNING DO NOT LEAVE CHILDREN UNATTENDED IN THE CAR. Fit the seat belt firmly to the child. A LOOSE RESTRAINT OR HARNESS IS DANGEROUS. Pass the shoulder belt through the belt sash guide (refer Figure 3) which is fastened to the restraint by a webbing strap.
  • Page 25: To Release Child

    To release your child from the restraint simply press the belt buckle carefully remove your child from the seat. It is not necessary to release the red belt clamp, to remove your child When the restraint is not in use, the seat belt should be fastened around it and engaged.
  • Page 26: Care Of Restraint

    CARE OF RESTRAINT TO REMOVE HARNESS Disengage shoulder straps from “G” connecting Step 1: plates as shown on page 12 (refer to section “Shoulder Slot Height” - Step 1 & 2). Step 2: Disengage buckle tongues from the buckle. Step 3: Pass the three bar slide located below the thigh harness slots on the end of each body/ shoulder straps through the thigh harness slots.
  • Page 27 IMPORTANT Use only mild soap and water to clean all parts of the CS7110/CS7210 Booster Seat. Do not use chemicals or cleaning agents Cold water only to be used and to be rinsed well Do not dry clean or tumble dry Do not bleach.
  • Page 28: Harness Buckle

    Harness Tongues and Buckle, then repeat cleaning several times. If the Harness Buckle cannot be returned to its original working condition then contact InfaSecure Customer Service. Figure 2 Step 5: Refit the harness buckle to the restraint with the red button facing out and feeding each 3-bar slide through appropriate slot.
  • Page 29: Cleaning / Care And Maintenance

    CARE OF RESTRAINT CARE AND MAINTENANCE Check the upper anchorage attachment clip to ensure plastic retainer clip is still present. Check the buckles “click” when you engage tongues and is not sluggish or sticky in operation. Check the harness adjuster is operating. TYPE B &...
  • Page 30 ACCESSORIES PADDED INSERTS (if fitted) The padded inserts are designed to add extra comfort for your child. Step 1: Disengage shoulder straps from “G” connecting plate as shown on page 12 (refer to section “Shoulder Slot Height” - Step 1 & 2). Step 2: Position the padded insert firmly back into the seating region of the seat.
  • Page 31 ACCESSORIES SHOULDER PADS (if fitted) The shoulder pad is designed to add extra comfort for baby or child. STANDARD Step 1: Separate press-studs and remove the STANDARD shoulder pads from harness Step 2: To attach shoulder pads, ensure press studs SPREADER face away from the child and re-attach.
  • Page 32 ACCESSORIES SEAT PROTECTOR (if fitted) The seat protector is designed to protect your car’s seat. STANDARD STANDARD Step 1: Position the front flap with pockets, at the front of the rear seat and position the mat rearwards to obtain a flat fit. FULL LENGTH Step 1: Position the front flap with pockets, at the...
  • Page 33 NOTES...
  • Page 34 NOTES...
  • Page 35 NOTES...
  • Page 36: Customer Service

    InfaSecure Warranty Details InfaSecure Pty Ltd warrants this product for twelve months from the date of purchase against failure due to manufacturing faults or faulty materials. Misuse, accidental damages, normal wear and tear are not covered by this warranty. When used for commercial use the period is limited to six months.

This manual is also suitable for:

Cs7210

Table of Contents

Save PDF