Shot Mark; Text Memo - Panasonic AJ-PX5000G Operating Instructions Manual

Hide thumbs Also See for AJ-PX5000G:
Table of Contents

Advertisement

5
Press the <SET> button to display the confirmation screen, and use the cursor buttons and the <SET> button to select [YES].
(Fig. 2)
The menu closes and the thumbnail for the clip is replaced.
@
NOTE
t You can view the thumbnail position (number of frames from the top of the clip) from the [THUMBNAIL] item of the clip information display. Since
thumbnails usually come from the top of the clip, 0 is displayed.
t Even if you change the thumbnail, playback from the thumbnail screen will still start from the beginning of the clip.
t The thumbnail image with the [!] mark may be displayed for clips of a format with a different number of lines and frequencies when displaying a text
memo clip without displaying the thumbnail of the text memo position displayed at the bottom section.

Shot mark

Shot marks can be added to a clip thumbnail to distinguish the clip from others.
1
Use the cursor buttons to move the cursor over the clip to which you want to add a shot mark.
2
Press the <SHOT MARKER> button.
f A shot mark is added to the thumbnail of the clip at the cursor position.
f To delete a shot mark, place the cursor again and press the <SHOT MARKER> button.
@
NOTE
t You can attach a shot mark during recording.
t Add shot marks after recording stops to attach the shot mark to the most recently recorded clip.
For details, refer to "Shot mark recording function" (page 42).
t When adding a shot mark to or deleting the shot mark from a clip recorded across multiple P2 cards, do this with all these P2 cards inserted into card
slots.
t [SHOT MARK] is assigned to the <SHOT MARKER> button in the factory setting. It can also be assigned to the <RET> button in the main menu →
[CAMERA] → [SW MODE].

Text memo

You can add text memos during recording or playback. Text memos can be used to play clips at some point or break clips into chunks and copy the
necessary portions.
Adding a text memo
1
Press the <TEXT MEMO> button while recording, playing, or displaying thumbnails.
f Pressing this button while recording or playing adds a text memo to the position when the button was pressed. At this time, [TEXT MEMO] (when
successful) or [TEXT MEMO INVALID] (when unsuccessful) is displayed.
f Pressing this button while the thumbnail screen is displayed inserts a text memo in the clip thumbnail (normally at the beginning) position.
@
NOTE
t Up to 100 text memos can be recorded to a single clip.
t Playback may stop for a moment when the <TEXT MEMO> button is pressed. This is not a malfunction.
t You cannot record text memos during loop recording.
Chapter 6 Thumbnail Operations for Clips — Thumbnail operations
<SHOT MARKER> button
<TEXT MEMO> button
– 128 –

Advertisement

Table of Contents
loading

Table of Contents