Table of Contents
Advertisement
Shooting techniques for different targets (continued)
2-slot continuous recording
You can also record continuously on three or
inserted into an empty slot (immediately after pre-
recording, or before or after continuous recording
remaining on the card that is recording.
The SLOT SEL button offers a one-touch
recorded.
•
this during recording standby.
•
Shot mark function
The marks attached to the thumbnails of clips
are called shot marks. On the thumbnail screen
mark and display them or play them back.
allocated, MARK ON appears in the LCD monitor
thumbnail of the clip being recorded. If you press
the button again, the shot mark is released.
You can also set or release the shot marks by
performing the thumbnail operations for clips.
(Page 66)
marks during playback.
•
shot marks.
•
When the video data of a single shoot using
you cannot set or release shot marks unless all
the P2 cards that make up the video data are
inserted into the slots.
•
You cannot set or release shot marks during loop
recording.
44
This function adds text memos at the video points
TEXT MEMO function has been allocated, the text
On the thumbnail screen you can select only those
then either display those clips or play them back.
You can record up to a hundred text memos per
clip.
•
You cannot record text memos during interval
recording or one-shot recording.
•
memos.
Time stamp function
Use the time stamp function to record date and
time of shooting on the video.
Select ON under TIME STAMP on the setting menu
RECORDING SETUP screen.
"
R
stamp function is on.
•
"
" is not recorded on the video.
R
•
•
The data recorded depends on the DATE/TIME
setting on the setting menu DISPLAY SETUP
selected.
•
Superimposed characters are output only during
42)
121)
Advertisement
Table of Contents
