Panasonic AJ-PX5000G Operating Instructions Manual page 63

Chapter 4 Adjustments and Settings for Recording — Adjusting the white and black balance
t During the automatic black balance execution, recording to the P2 card is not performed by pressing the <REC> button.
t The gain switching circuit is automatically switched during black balance adjustment. Flicker or noise sometimes appears on the viewfinder screen.
This is not a malfunction.
t Even after automatic black balance has ended, if black shading is a cause for concern, select [DETECTION(DIG)] in the main menu →
[MAINTENANCE] → [BLACK SHADING], and execute black shading adjustment. Alternatively, set the main menu → [CAMERA] → [SW MODE]
→ [SHD,ABB SW CTL] to [ON] and hold down the <AUTO W/B BAL> switch for two seconds or more to adjust black shading. [B-SHD READY] will
be displayed in the viewfinder, and black shading can be automatically adjusted after the automatic black balance operation. While black shading is
being adjusted, [B-SHD ACTIVE] will be displayed in the viewfinder. After this, be sure to close down the lens aperture until [B-SHD OK] is displayed
in the viewfinder. However, when the remote control unit AJ-RC10G (optional), extension control unit AG-EC4G (optional), or remote operation panel
AK-HRP200G (optional) is connected, black shading cannot be automatically adjusted even by holding down the <ABB> switch.
t When black balance is being automatically adjusted (when [ABB ACTIVE] is displayed in the viewfinder), adjustment is canceled by pushing the
<AUTO W/B BAL> switch towards <ABB> again. The adjustment values at this time return to the values before automatic adjustment was performed.
Black balance memory
Values stored to memory are saved even if the camera is turned off.
– 63 –