Panasonic AJ-PX5000G Operating Instructions Manual page 136

Contents of P2 card status display settings
Select [CARD STATUS] in the main menu → [CLIP] → [PROPERTY].
r When [REMAIN] is selected
r When [USED] is selected
1 Write-protected mark
The mark appears when the P2 card is write-protected.
2 P2 card status (remaining capacity)
The remaining memory capacity of the P2 card is shown as a bar graph and percentage. The bar graph indicator moves to the left as the remaining
capacity decreases.
The following displays may also appear, depending on the card status.
[FORMAT ERROR!]
[NOT SUPPORTED!]
[NO CARD]
[AUTH NG CARD]
Use the cursor buttons to place the cursor on the P2 card for data to be accessed and press the <SET> button to display detailed information on the
P2 card. Specific information such as the serial number and the user ID can be checked. (Fig. 1)
When the maximum number of clips that can be recorded in the P2 card has been reached, [OVER MAX NUMBER CLIPS] is displayed in the P2
card detailed information showing that the upper limit has been reached.
3 Warning card mark
When P2 cards are the following status, the
[RUN DOWN CARD]
[DIR ENTRY NG]
The warning can be checked on the P2 card detailed information in "P2 card status (remaining capacity)" (page 136). (Fig. 2)
Chapter 6 Thumbnail Operations for Clips — Thumbnail operations
1
3
4
1
3
4
Fig. 1
An unformatted P2 card is inserted.
An unsupported card is inserted.
No P2 card is inserted.
Indicates that the card is a microP2 memory card which cannot authenticate a CPS password.
mark is displayed.
The maximum number of overwrites on the P2 card has been exceeded.
The directory structure on the P2 card is not supported.
2
2
– 136 –
5
5
Fig. 2