Recording The Proxy Data; Recording To The Sd Memory Card - Panasonic AJ-PX5000G Operating Instructions Manual

Item
[STREAMING LATENCY]
f Proxy data cannot be recorded in the following modes.
- Interval recording (including one-shot recording)
- Loop recording
- When [ONE FILE] is set in the main menu → [REC/PB] → [REC/PB SETUP] → [FILE SPLIT].
- When [ON] is set in the main menu → [REC/PB] → [REC FUNCTION] → [SIMUL REC].
- When [ON] is set in the main menu → [REC/PB] → [REC FUNCTION] → [ONE CLIP REC].
Checking the setting status
By pushing the <MODE CHECK/MENU CANCEL> switch on the camera towards the <MCK/MCL> side three times, you can check the menu values of
the superimposition settings of the recording media, recording mode, and time code display of proxy data through mode check.
Recording modes and recording signals (video/audio)
r Video
Recording mode File format
[STD 2CH MP4] MP4
[LOW 2CH MOV] MOV
[HQ 2CH MOV] MOV
[HQ 4CH MOV] MOV
[SHQ 2CH MOV] MOV
[AVC-G6 2CH MOV
MOV]
* When the recording mode is 720/30P, 720/25P, or 720/24P in [AVC-G6 2CH MOV], bitrate is 3 Mbps.
r Audio
Recording mode File format
[STD 2CH MP4] MP4
[LOW 2CH MOV]
MOV
[HQ 2CH MOV] MOV
[HQ 4CH MOV] MOV
[SHQ 2CH MOV] MOV
[AVC-G6 2CH
MOV
MOV]

Recording the proxy data

Select [PROXY REC(P2)] or [PROXY REC(P2&SD)] in main menu → [REC/PB] → [DUAL CODEC SETUP] → [CODEC USAGE] and press the <REC>
button to start proxy recording at the same time as recording of the materials.
Push the <MODE CHECK/MENU CANCEL> switch towards the <MCK/MCL> side three times to display the proxy data recording information on the
viewfinder screen.

Recording to the SD memory card

To record the proxy data, use SD, SDHC, or SDXC memory cards with an indication of class2 or higher. For the latest information not included in these
Operating Instructions, refer to the support desk at the following website.
http://pro-av.panasonic.net/
When recording the proxy data to an SD memory card, always format the card using the camera.
Chapter 3 Recording and Playback — Dual codec recording
Sets the delay mode during the streaming distribution. This setting is used when the streaming distribution
is started from the operation of the camera.
This can be set when the main menu → [I/F SETUP] → [USB/LAN] → [STREAMING SETTING] → [START
TRIGGER] is set to [CAMERA].
[NORMAL]: Set if you want to emphasize the stability of streaming.
[SHORT]: Set if you want to emphasize the reduction of streaming delay.
f Factory setting: [NORMAL]
Resolution
320×240 (QVGA)
1080i mode
480×270
1080/59.94P mode
320×180
1080/50P mode
320×180
480/59.94i mode
352×240
576/50i mode
352×288
640×360
640×360
960×540
1080i mode
1920×1080
720P mode
1280×720
Codec
AAC-LC
AAC-LC
AAC-LC
AAC-LC
LPCM
AAC-LC
– 45 –
Description of settings
Codec Frame rate
MPEG-4 30 fps/24 fps/25 fps
Simple Profile
H.264 30 fps/25 fps
Baseline Profile
60 fps/50 fps
30 fps/25 fps
H.264 30 fps/25 fps
High Profile
H.264 30 fps/25 fps
High Profile
H.264 30 fps/25 fps
High Profile
H.264 60 fps/50 fps
High Profile
Number of channels Bitrate per channel
2ch
2ch
2ch
4ch
2ch
2ch
Bitrate
1500 kbps
800 kbps
1500 kbps
1500 kbps
3500 kbps
6 Mbps*
Sampling frequency
64 kbps 24 kHz
64 kbps 48 kHz
64 kbps 48 kHz
64 kbps 48 kHz
768 kbps 48 kHz
64 kbps 48 kHz