Fitting Sides & Switch - Fs Models - Valor 530 Direct Vent Installation Manual

1. a) For active appliance side switch as only active switch
•
Snap fit the switch into the opening in the switch mounting bracket.See figure 63
•
Fit the two wire clips to the right side of the case.
•
Route the switch wires round the back of the valve and connect to the control unit.
•
Connect the battery box to the black connection pad. See figure 64.
•
Place the battery box on the "Velcro" pad in front of the battery shield. Fit the wires
into the clips. See figure 64.
b) For active wall switch
The "L" shaped terminals on the 20ft wall switch wires connect with the burner control
unit. Route the wires round the back of the burner to the wall switch location.
The connections at the wall switch are shown in figure 60.
Fit the batteries supplied with the engine unit to the holder supplied with the wall switch.
Fit the wall switch plate to your switch box.
c) For active remote control without active appliance switch
Caution! Don't connect the batteries in the remote control receiver until the wires are
connected to the burner control unit. A short circuit could result in destruction of the
electrical components.
Route the wires from the receiver round the back of the burner and connect to the control
unit. Remove the receiver lid. Connect the battery box to the receiver wires. Fit the four
1.5 V batteries. Replace the receiver lid.
Place the remote control receiver on the "Velcro" pad in front of the battery shield. See
figure 62.
Fit the 9V battery to the handset transmitter.
d) For active remote control with active appliance side switch
Caution! Don't connect the batteries in the remote control receiver until the wires are
connected to the burner control unit. A short circuit could result in destruction of the
electrical components.
A set of four batteries and battery box is supplied with the appliance and a further set with
the remote control unit. Only one set is required. The other set can be kept by the owner as
spares.
•
Snap fit the switch into the opening in the switch mounting bracket. See figure 63.
•
Fit the two wire clips to the right side of the case.
•
Cut off the "L" terminals from the switch wires on the remote control receiver and
remove insulation from approximately ¼" at ends of wires. See figure 60a.
•
Securely connect the wires to the terminal block. Connect the black wire to the
terminal opposite the brown wire. Connect the wire with the white stripe to the
terminal opposite the yellow wire. See figure 60b.
•
Route the wires round the back of the valve and connect the "L" terminals to the
control unit.
•
Remove the remote control receiver lid. Remove the cover from the white connection
pad. Fit this connection pad to the remote control receiver terminals. See figure 60c.
•
Fit the black connection pad to a battery box. Fit four 1.5V batteries. See figure 60c.
•
Place the batteries and connection pad in the receiver box and replace the lid.
•
Fit the 9V battery to the handset transmitter.
2. Fit the sides to the engine unit case with two machine screws and washers per side.
See figure 65.
3. For active appliance side switch
Fit the switch mounting bracket to the right side casting with two thread cutting screws
supplied. The wires should hang down from the connectors at back of the switch so that
pressing the upper arrow on the switch turns the fire up. See figure 66.
12. FITTING SIDES & SWITCH – FS MODELS
Manufactured by Miles Industries Ltd., British Columbia, Canada
34
Figure 63
Figure 64
Figure 65
Figure 66