Preparing Wall Plates; Installations Except With Valor #551Dvk Terminal - Installing To Wall - Valor 530 Direct Vent Installation Manual

Preparing Wall Plates

The wall plates are not used for 7" hole in non-combustible walls.
1. Bend the wall shields and screw to the inside of the wall plates with 6 thread cutting
screws per plate. see figure 53.
2. Bend the inner wall plate tab as shown in figure 54 so that the seam on the terminal
tube will pass clearly through the plate with the wall shield at the top. Place the inner
wall plate over the terminal unit. Slide the appliance towards the wall so that the
terminal enters the wall. Slide the inner wall plate up to the wall. Mark the four holes
for the wall screws. Slide the plate away.
3. Drill and plug the wall.
4. Screw the plate to the wall with 4 screws provided.
9.4.1. Installing Appliance to Wall.
1. Slide the appliance fully up to the wall.
2. Bend the outer wall plate tab as shown in figure 54. Place the outer wall plate over
the terminal unit. Slide the wall plate up to the wall. Mark the four holes for the wall screws. Slide the plate away.
3. Drill and plug the wall.
4. Screw the plate to the wall with 4 screws provided.
See figure 55.
5. FS installations - Secure the appliance to the floor or wall if necessary.
Figure 54
9.5. Installations except with Valor #551DVK Terminal – Installing to wall
Unless the wall is totally non-combustible, fit Dura-vent wall thimbles #942.
Slide the appliance into its correct position and install as detailed in the Duravent instructions supplied with the pipes.
FS installations - Secure the appliance to the floor or wall if necessary.
Manufactured by Miles Industries Ltd., British Columbia, Canada
Figure 55
30
Figure 53