Rear Vent Outlet Preparation - Valor 530 Direct Vent Installation Manual

8.5.

Rear Vent Outlet Preparation

8.5.1. For Installations With Dura-Vent DV GS Pipes
If installing flat on wall with Valor terminal kit #551DVK, ignore this step :
1. Fit the Dura-vent adapter #817VAK over the appliance vent collars
pushing on firmly.
Align the adapter so that the seam on horizontal Dura-vent pipes is not at
the bottom – Check by temporarily fitting a Dura-vent pipe.
2. Drill through the adapter outer tube and appliance outer collar for #6
screws. See figure 40. Make sure that the drill does not penetrate the
inner tubes.
3. Secure the adapter to the outer collar with two #6 thread cutting screws
supplied (Fig. 40).
8.5.2. For Installations With Dura-Vent DV GS Co-Linear
Liners:
1. Fit the Dura-vent adapter #817VAK over the appliance vent collars
pushing on firmly.
2. Fit and fully twist-lock the Dura-vent co-axial to co-linear connector
#923GCL to the #817VAK adapter.
3. Keeping the connector and adapter fully twist-locked, rotate them so that
the air inlet collar on the connector is at the bottom. See figure 41.
4. Drill through the adapter outer tube and appliance outer collar for #6
screws. See figure 40. Make sure that the drill does not penetrate the
inner tubes.
5. Secure the adapter to the outer collar with two #6 thread cutting screws supplied (Fig. 40).
8.6.
Manufactured by Miles Industries Ltd., British Columbia, Canada
Figure 40
Figure 41
24