Table of Contents
Advertisement
2.1
UNPACKING THE FIRE
Carefully lift the fire out of the carton. Remove the loose item packaging carefully
from the front of the appliance. Check the contents as listed :-
Packing Check List
1 off
Combustion chamber, collection hood, spigot outlet & heat baffle
1 off
Spigot outlet hood / debris deflector
1 off
Trim / Glass mounting frame assembly
1 off
Loose items bag including :-
1 off Remote control handset
1 off each User instruction book and Installation book
1 off piece of foil tape to seal un-used gas inlet apertures in the firebox
1 off Fuel-bed ceramic set
IMPORTANT NOTE BEFORE PROCEEDING WITH THE INSTALLATION
This product requires a minimum effective flue height of 4.0 metres of minimum
circular cross-sectional area 125mm. If installing the product into a 225mm x
225mm brick chimney, THE CHIMNEY SOUNDNESS MUST BE CHECKED BY
TESTING AND A THOROUGH ON SITE VISUAL INSPECTION prior to a decision
being made on whether the chimney requires lining. If the flue height is greater
than 10 metres on an external wall or 12 metres on an internal wall then a flue
liner must be fitted even if the chimney integrity is ok.
Please check the chimney height and integrity prior to proceeding with the
installation, to establish if a chimney liner is required. Any flue pipe should
conform to BS 715 / BS EN 1856-2 (Metal flue pipes for gas appliances).
When you have decided upon if the product requires the fitting of a flue
liner, proceed with the creation of the correct sized builders opening or
studwork installation of the product as per sections 2.3 or 2.4
Please also be aware that due to the requirement to allow a minimum
volumetric area of 12 litres behind the product for flue debris collection, the
depth required for installation without a flue liner increases from 305mm to
385mm.
SECTION 2
INSTALLATION OF FIRE
8
Advertisement
Table of Contents
