Table of Contents
Advertisement
Servicing Notes
Servicing should be carried out annually by a competent person such as a CORGI
registered engineer. The service should include visually checking the chimney and
fire opening for accumulations of debris and a smoke test to check for a positive
up-draught in the chimney.
The condition of the ceramic gravel pieces should be checked and the fuel-bed
overlay replaced on an annual basis with a genuine item.
The burner assembly is designed to be removed as a complete unit for ease of
access. After any servicing work a gas tightness check must always be
carried out.
For Diagrams refer to Section 2
4.1
Removing the burner assembly from the fire.
4.1.1
Prepare work area (lay down dust sheets etc.)
4.1.2
Remove the "Pure" fascia from the product as shown in section 2.9 on
page 15 and put it in a safe location.
4.1.3
Isolate the gas supply and remove the loose gravel from the appliance
Unscrew the glass panel retaining brackets and remove the glass panel
Remove the fuel-bed mounting board (fibre). Unscrew the 8 off fuelbed
mounting plate retaining screws and lift clear.
4.14
Unscrew the injector retaining nut in the venturi at the rear of the burner
assembly. Unscrew the 2 off pilot retaining screws. Unscrew the 4 off
burner retaining screws on the base brackets, the burner should then be
lifted out of the combustion chamber. NOTE : Please take care with
the wiring loom which runs from left to right in front of the burner
4.1.5
To refit the burner assembly, replace in reverse order and re-fit the the
"Pure" fascia as described in section 2.9 on page 15.
4.2
Removing the Gas Valve from the fire.
4.2.1
Prepare work area (lay down dust sheets etc.)
4.2.2
Remove the "Pure" fascia from the product as shown in section 2.9 on
page 15 and put it in a safe location.
4.2.3
Isolate the gas supply and remove the loose gravel from the appliance
Unscrew the glass panel retaining brackets and remove the glass panel
Remove the fuel-bed mounting board (fibre). Unscrew the 8 off fuelbed
SECTION 4
MAINTENANCE
20
Advertisement
Table of Contents
