Table of Contents
Advertisement
1.7
INSTALLATION WITH OR WITHOUT A FLUE LINER
Ensure that if installing this product into a brick built chimney, the chimney has
been fully swept prior to proceeding with the installation.
Any flue liner must have a minimum temperature rating of T250.
The effective flue height must be a minimum of 4 metres if using 125mm diameter
liner and as with all hole in the wall type room heater, please ensure that you are
measuring the effective flue height from the top of the combustion chamber, not
the base of the chimney.
A 125mm diameter spigot adaptor is supplied with the product and is fitted to the
integral collection hood, for use if installing with a flue liner
The product can be installed without a flue liner, by using the spigot outlet hood /
debris deflector, but the chimney must meet the requirements as detailed on
pages 8 & 13 of this manual. If the chimney does not meet these requirements. it
must be fully lined throughout it's length.
1.8
SPILLAGE MONITORING SYSTEM
This appliance is fitted with an atmosphere sensing spillage monitoring system in
the form of an oxygen sensing pilot. This is designed to shut the fire off in the
event of a partial or complete blockage of the flue causing a build up of
combustion products in the room in which the fire is operated. The following are
important warnings relating to this spillage monitoring system :-
1) The spillage monitoring system must not be adjusted by the installer.
2) The spillage monitoring system must not be put out of operation.
3) When the spillage monitoring system is exchanged only a complete original
manufacturers part may be fitted. It is not possible to replace individual parts on
the pilot system on this appliance, only a complete pilot assembly (including the
thermocouple) may be fitted.
7
Advertisement
Table of Contents
