Installation Of Fire; Unpacking The Fire; Installing The Combustion Chamber & Closure Plate - Flavel Kamina Installation And Maintenance Instructions Manual

2.1

UNPACKING THE FIRE

Carefully lift the fire out of the carton. Remove the loose item packaging carefully
from the front of the appliance. Check the contents as listed :-
Packing Check List
1 off Combustion chamber and glass frame assembly
1 off Loose items bag including :-
1 off Remote control handset
1 off 6mm Allen key
1 off each User instruction book and Installation book
4 off 1.5V Batteries
1 off Spigot & fitting screws
1 off valve cover
2 off M5 screws (to fit fascia to base brackets)
1 off Kamina Fascia
1 off Closure Plate
2.2 INSTALLING THE COMBUSTION CHAMBER & CLOSURE PLATE
Establish which type of flue you are intending to install the fire in to :-
225 x 225mm (9 inch x 9 inch) brick built chimneys
175mm (7 inch) diameter lined brick or stone flue, or insulated pre-fabricated
metal flue box to B.S. 715.
When installing into 125mm (5 inch) diameter lined brick or stone flue, or
insulated pre-fabricated metal flue box to B.S. 715 and pre-cast flues the
restrictor baffle must not be fitted.
A spillage test must always be carried out to check satisfactory
clearance of flue products, regardless of the type of flue the
appliance is being fitted to.
PLEASE NOTE :- IF INSTALLING THIS PRODUCT INTO A HOLE IN THE WALL
TYPE INSTALLATION IN WHICH THE FLUE TYPE IS PRE-CAST, SPECIALIST
ADVICE MUST BE OBTAINED FROM A STRUCTURAL ENGINEER
REGARDING THE RE-POSITIONING OF THE STARTER BLOCKS.
UNDER NO CIRCUMSTANCES SHOULD THE FIRE BE RECESSED INTO THE
GATHER BLOCK, OFFSET OR STRAIGHT FLUE BLOCKS.
SECTION 2

INSTALLATION OF FIRE

10