Flavel Pure FPRG**RN2 User Instructions
Decorative fuel effect gas fire
Hide thumbs
Also See for Pure FPRG**RN2:
Related Manuals for Flavel Pure FPRG**RN2
Summary of Contents for Flavel Pure FPRG**RN2
- Page 1 Pure DECORATIVE FUEL EFFECT GAS FIRE User Instructions Model No’s FPRG**RN2 is for use on Natural Gas (G20) at a supply pressure of 20 mbar in G.B. / I.E. NB: “**” refers to fascia variant...
-
Page 2: Installation Information
INSTALLATION INFORMATION CONDITIONS OF INSTALLATION It is the law that all gas appliances are installed in accordance with the rules in force only by a competent (e.g. CORGI Registered) Installer in G.B, and in accordance with the installation instructions and the Gas Safety (Installation and Use) Regulations 1998. - Page 3 ABOUT YOUR NEW FLAVEL “PURE” GAS FIRE The Flavel “Pure” decorative fuel effect gas fire incorporates a unique and highly developed burner and fuel-bed system. The use of durable ceramic material in the construction of the fuel-bed ensures long and trouble free operation.
-
Page 4: Spillage Monitoring System
SPILLAGE MONITORING SYSTEM This appliance is fitted with a spillage monitoring system which shuts down the fire if the evacuation of combustion products from the fire is affected by a partially or fully blocked flue pipe. If this system operates the fire will go out. If this occurs, leave the fire for at least three minutes then follow the lighting procedure as described in the previous section. - Page 5 OPERATING THE FIRE USING THE REMOTE CONTROL HANDSET Remove the “Pure” fascia as shown on page 7 of this book. The control valve is positioned on the left hand side of the fire when viewed from the front. To operate the appliance automatically via the remote control handset, ensure that the on / off switch is switched to the “on”...
- Page 6 Fig. 2 “LED” handset light “UP” button “DOWN” / “STANDBY” “STAR” / “OFF” button button To reduce the heat input, press the “DOWN / STANDBY” button until the flame reduces to the low rate heat input setting (4.2kW). If you continue to hold the “DOWN / STANDBY”...
- Page 7 REMOVAL & RE-FITTING THE “PURE” FASCIA The “Pure ” fascia is fitted to the product by hooking the top edge of the fascia over the mounting brackets as shown in Fig. 3 below, then securing with magnets at the bottom. Fig.
- Page 8 The ceramic fibre back & imitation gravel used in this product is manufactured from R.C.F (Refractory Ceramic Fibre). To ensure that the release of fibres from this item is kept to a minimum, during installation and servicing we recommend that you use a HEPA filtered vacuum to remove any dust accumulated in and around the appliance before and after working on the appliance.
-
Page 9: User-Replaceable Parts
USER REPLACEABLE PARTS We do not recommend any parts on this appliance are replaced by anyone other than a CORGI registered engineer, with the exception of the following user replaceable parts :- Fuel-bed Mounting Board (Black Fibre) B-96000 Fuel-bed Mounting Board (Beige Fibre) B-97420 Fuel-bed gravel set (Grey / Cream 100 off approx.