Removing Right-Side Components - Arctic Cat 2016 Alterra 500 Service Manual

Removing Right-Side
Components
A. V-Belt Cover
B. Driven Pulley
C. Clutch Cover
1. If the engine is still in the frame, remove the cap
screw securing the brake pedal to the pedal axle.
Account for a flat washer.
KC149A
2. Remove the cap screws securing the V-belt cover to
the clutch cover; then slide the brake pedal outward
and remove the V-belt cover. Account for two align-
ment pins and a gasket.
KC142A
3. Mark the movable drive face and the fixed drive face
for installing purposes; then remove the nut holding
the movable drive face onto the crankshaft.
MD1033
52
4. Remove the movable drive face and spacer. Account
for the movable drive face rollers and outer drive
face cover.
MD1035
MD1034
MD1036
5. Using a 6 mm cap screw threaded into the fixed
driven face, spread the driven pulley by turning the
cap screw clockwise; then remove the V-belt.
KC132
6. Remove the fixed drive face.