Arctic Cat 2016 Alterra 500 Service Manual page 150

CF266A
CF267A
4. Apply a liberal coat of grease to the O-ring; then
install it on the assembled cover assembly making
sure to seat the O-ring completely down around the
circumference of the bearing flange.
CF275A
5. Making sure the O-ring is properly positioned on the
differential housing cover assembly, install the cover
with existing cap screws (coated with green Loctite
#609). Tighten the cap screws evenly to 23 ft-lb
(existing housing) or 28 ft-lb (new housing).

NOTE: Grease can be applied to the O-ring for ease
of assembling.
6. Install the shift fork shaft w/spring into the housing
making sure the shaft O-ring is positioned to the
inside.
CC892
7. Install the shift fork assembly making sure the fork
leg is facing upward. Apply a small amount of oil to
the gasket; then install the gasket.
CC893
8. Place the input shaft assembly onto the gear case
housing; then secure with the existing cap screws.
Tighten to 23 ft-lb (existing housing) or 28 ft-lb (new
housing).
CD103
CD110
149