Arctic Cat 2016 Alterra 500 Service Manual page 47

FI539
FI541
3. Remove two cap screws and the oil bolt securing the
oil pressure relief line to the engine. Account for two
crush washers and an O-ring.
FI544
4. Remove the water pump drive gear; then remove the
speed sensor housing assembly. Account for two
alignment pins, a gasket, and two seal washers.
FI543
46
5. Remove the cap screws securing the magneto cover
to the crankcase. Note the location of the two inter-
nal cap screws and the two longer cap screws.
FI596A
6. Remove the magneto cover and account for two
alignment pins and the gasket.
D. Rotor/Flywheel
E. Starter Clutch/Gear
F. Starter Motor

NOTE: Steps 1-6 in the preceding sub-section must
precede this procedure.
7. Remove the nut securing the rotor/flywheel on the
crankshaft and install the crankshaft protector.
FI549
8. Using the Magneto Rotor Remover Set, break the
rotor/flywheel loose from the crankshaft; then
remove the puller and crankshaft protector and
remove the rotor/flywheel.
FI550
9. Remove the flywheel key from the crankshaft; then
remove the starter clutch gear.