Arctic Cat 2016 Alterra 500 Service Manual page 55

MD1016
13. Remove the cam chain.
FI630
14. Remove the oil pump drive gear cap screw.
MD1018
15. Remove oil pump drive gear. Account for the pin.
MD1017
16. Remove the snap ring holding the oil pump driven
gear.
54
MD1019

NOTE: Always use a new snap ring when installing
the oil pump driven gear.
17. Remove oil pump driven gear. Account for the drive
pin and thrust washer.
MD1020
AT THIS POINT

To service clutch components, see Servicing Right-Side
Components sub-section.
G. Oil Pump/Oil Strainer

NOTE: Steps 1-17 in the preceding sub-sections
must precede this procedure.
18. Remove three cap screws holding the oil pump and
remove the oil pump. Account for two alignment
pins.
MD1060
19. Remove the four cap screws securing the oil strainer
cap; then remove the Phillips-head screws securing
the oil strainer. Account for the O-ring.