Table of Contents
Advertisement
Do not change the adjustment value excessively.
13.4.3.2 Adjusting the Horizontal Registration
iR1020J / iR1024J / iR1020 / iR1024 / iR1024A / iR1024N / iR1024F / iR1024i / iR1024iF
1) Load the test chart in the ADF and make a copy of it.
2) Compare the horizontal registration of the chart with that of the copy. If required, make an adjustment.
The specified horizontal registration is 10mm +/-2mm.
1) Load the test chart in the ADF and make a copy of it.
2) Compare the horizontal registration of the chart with that of the copy. If required, make an adjustment.
The specified horizontal registration is 10mm +/-2mm.
3) Enter the service mode.
Sequentially press the Additional functions key, 2 key, 8 key, and Additional functions key on the operation panel of the host machine.
4) Using the arrow keys on the operation panel, display "#SCAN".
5) Press the OK key.
6) Using the arrow keys on the operation panel, display "#SCAN NUMERIC".
7) Press the OK key.
8) Using the arrow keys, select "41".
9) Using the numeric keys, change the value to determine the optimum value. Next, press the OK key. (Default: 0)
If the registration cannot be set to the specified value using software, use the following procedure:
1) Open the ADF pickup tray.
2) Loosen the two screws [1] and move the slide guide forward or backward according to the scale calibrated in mm so that the registration is within spec.
MEMO:
Making copies with the slide guide shifted 1 mm upward will increase the right registration (on the upper side of paper) by 1 mm.
13.4.3.3 Leading edge registration adjustment
iR1020J / iR1024J / iR1020 / iR1024 / iR1024A / iR1024N / iR1024F / iR1024i / iR1024iF
1) Load the test chart in the ADF and make a copy of it.
2) Compare the end registration of the test chart with that on the copy. If required, make an adjustment.
10±2mm
(feeding direction)
Copy of the test sheet
F-13-11
[1]
F-13-12
0013-1279
0013-1280
Advertisement
Chapters
Table of Contents
