Use it to specify whether to convert or not convert an inch-configuration resolution into a millimeter-configuration resolution for image read in G3 transmission:

either in sub scanning direction only or in both main and sub scanning directions. The setting is valid only when bit 1 of SW05 of #SSSW is set to '1'.

16.3.8.3 Detailed Discussions of Bit 4

iR1020J / iR1024J / iR1020 / iR1024 / iR1024A / iR1024N / iR1024F / iR1024i / iR1024iF

Use it to specify whether to declare or not declare an inch-configuration resolution to the other machine for G3 communication: if 'declare' is selected, the machine

will indicate that it reads and records at an inch-configuration resolution using the DIS, DCS, or DTC signal.

16.3.9 SSSW-SW28

16.3.9.1 List of Functions

iR1020J / iR1024J / iR1020 / iR1024 / iR1024A / iR1024N / iR1024F / iR1024i / iR1024iF

Bit

16.3.9.2 Detailed Discussions of Bit 0

iR1020J / iR1024J / iR1020 / iR1024 / iR1024A / iR1024N / iR1024F / iR1024i / iR1024iF

Select whether to use the V.8 protocol when calling. If NO is selected, the V.8 protocol is inhibited at calling and the V.21 protocol is used.

16.3.9.3 Detailed Discussions of Bit 1

iR1020J / iR1024J / iR1020 / iR1024 / iR1024A / iR1024N / iR1024F / iR1024i / iR1024iF

Select whether to use the V.8 protocol when called. If NO is selected, the V8 protocol is inhibited when called and the V.21 protocol is used.

16.3.9.4 Detailed Discussions of Bit 2

iR1020J / iR1024J / iR1020 / iR1024 / iR1024A / iR1024N / iR1024F / iR1024i / iR1024iF

If ANSam signal is not received during transmission, select whether to use the V.8 protocol when the other fax machine declares the V.8 protocol in DIS signal. If

16-14

Function

not used

direction of scanning for inch/mm conversion

not used

inch-configuration resolution declaration

not used

Function

Caller V.8 protocol

Called party V.8 protocol

Caller V.8 protocol late start

Called party V.8 protocol late start