Upnp Device Ttl; Upnp Device Advertise Duration - Edge-Core ES3510 Management Manual

Example
In the following example, UPnP is enabled on the device.
Console(config)#upnp device
Console(config)#
Related Commands

upnp device ttl (4-317)

upnp device advertise duration (4-317)

upnp device ttl
This command sets the time-to-live (TTL) value for sending of UPnP messages from
the device.
Syntax
upnp device ttl {value}
• value - The number of router hops a UPnP packet can travel before it is
discarded. (Range:1-255)
Default Setting
4
Command Mode
Global Configuration
Command Usage
UPnP devices and control points must be within the local network, that is
within the TTL value for multicast messages.
Example
In the following example, the TTL is set to 6.
Console(config)#upnp device ttl 6
Console(config)#
upnp device advertise duration
This command sets the duration for which a device will advertise its presence on the
local network.
Syntax
upnp device advertise duration {value}
value - A time out value expressed in seconds. (Range: 6-86400 seconds)
Default Setting
100 seconds
4
UPnP Commands
4-317