Konica Minolta bizhub C250 User Manual page 582

Utility
8
Check that the distance
from the starting print
position of the test pat-
tern to the edge of the
paper (a) is 4.2 mm.
– If the distance is less
than 4 mm, touch [+]
to increase the ad-
justment (between
0.2 mm and 3.0 mm).
– If the distance is
more than 7 mm,
touch [–] to reduce
the adjustment (between –0.2 mm and –3.0 mm).
– To scroll through the values quickly, touch [+] or [–] continuously.
9
Press the [Start] key.
The adjusted test pattern is printed.
10
Check the distance from the starting print position of the test pattern
to the edge of the paper.
– Check that the width has been adjusted to 4.2 mm.
– If more adjustment is necessary, repeat steps 8 and 9.
– To adjust the print position for a different type of paper, return to
step 6.
11
Touch [OK].
– To cancel changes to the settings, touch [Cancel].
The print position is adjusted.
Note
Enter the value by mm using the keypad.
Refer to the conversion rate below.
1 in. = 25.4 mm
C250
a: 4.2 mm
12
a
12-51