Konica Minolta bizhub C250 User Manual page 232

Additional copy operations
7
Press the [Proof Copy] key to print another sample copy.
– If copying stops while the proof copy screen is displayed after the
proof copy was printed, press the [Reset] key.
Otherwise, from the list of jobs on the sub display area, select the
proof copy job that stopped, and then touch [Delete]. In the screen
that appears, requesting confirmation to delete the copy program,
touch [Yes].
– If an automatic system reset operation is performed while the proof
copy for a job is being checked, that job is stored in the memory.
– If the "System Auto Reset" parameter is set to "OFF", the job is
added to the Held Jobs list after no job is performed for one minute.
– To stop the proof copy while scanning or printing, perform the op-
eration described in "Stopping scanning/printing" on page 3-86.
– If multiple copies have been specified, another sample copy can be
printed.
– The number under "# of Sets" in the Change Setting screen is the
number of copies that will be printed when [Print] is touched.
– The number under "Number of Sets" in the screen that appeared
when a sample copy is printed indicates the number of copies that
are sample copies/total number of copies specified.
– The number under "Number of Pages" in the screen that appeared
when a sample copy is printed indicates the number of copies that
are sample copies/the number of pages in the sample copy.
8
Touch [Print].
The remaining copies are queued as a copy job.
C250
4
4-7