KYMCO VITALITY 50 Manual page 225

14.
STEERING HANDLEBAR/FRONT WHEEL/FRONT
BRAKE/FRONT SHOCK ABSORBER/FRONT FORK
Place the brake master cylinder on the
handlebar and install the holder with "up"
mark facing up. Be sure to align the punch
mark with the holder joint.
First tighten the upper bolt and then tighten
the lower bolt.
Torque: 1.0 1.4kgf-m
Install the brake fluid pipe with the
attaching bolt and two sealing washers.
Fill the brake reservoir with recommended
brake fluid to the upper limit and bleed air
according to the method stated in 14-8.
BRAKE CALIPER (FRONT)
Removal
Remove the brake caliper. ( 14-9)
Place a clean container under the brake
caliper and disconnect the brake fluid pipe
from the caliper.
Do not spill brake fluid on any coated
surfaces.
Punch Mark
"Up" Mark
VITALITY 50
Bolts
Bolt
14-12