9
. KICK STARTER/DRIVE PULLEY/
CLUTCH/DRIVEN PULLEY
DRIVEN PULLEY FACE BEARING
REPLACEMENT
Check the needle bearings in the driven face
and replace them if they have excessive
play, damage or abnormal noise.
Drive the inner bearing out of the driven
pulley face.
Remove the snap ring and drive the outer
bearing out of the driven face.
Drive a new outer bearing into the driven
face with the sealed end facing up.
Seat the snap ring in its groove.
Pack all bearing cavities with 5.0 5.6g
grease.
Specified grease: 230 Heat-resistant
9-15
grease
Inner Bearing
Bearing Outer Driver
VITALITY 50
Outer Bearing