Dhcp Auto Configuration Settings - D-Link DGS-3200-16 - Switch - Stackable User Manual

xStack
Parameter Description
DHCP Local Enable or disable the DHCP Local Relay Global State. The default is Disabled.
Relay Global
State
This is the VLAN Name that identifies the VLAN the user wishes to apply the DHCP Local Relay
VLAN Name
operation.
State Enable or disable the Config DHCP Local Relay for VLAN state.
DHCP/BOOTP This is a list of VLAN IDs the user wishes to apply the DHCP/BOOTP Local Relay operations.
Local Relay
VID List
Click Apply to implement the new DHCP Local Relay Settings.

DHCP Auto Configuration Settings

This window is used to enable the DHCP auto configuration feature on the Switch. When enabled, the Switch is instructed to
receive a configuration file from a TFTP server, which will set the Switch to become a DHCP client automatically on boot-up. To
employ this method, the DHCP server must be set up to deliver the TFTP server IP address and configuration file name
information in the DHCP reply packet. The TFTP server must be up and running and hold the necessary configuration file stored
in its base directory when the request is received from the Switch. For more information about loading a configuration file for use
by a client, see the DHCP server and/or TFTP server software instructions. The user may also consult the Upload Log File
window description located in the Tools section of this manual.
If the Switch is unable to complete the DHCP auto configuration, the previously saved configuration file present in the Switch's
memory will be used.
To view the following window, click Configuration > DHCP Auto Configuration Settings:
To enable the DHCP Auto Configuration State, use the pull-down menu to choose Enabled and click the Apply button.
The following parameter may be configured or viewed:
Parameter Description
Auto
Enable or disable the Switch's DHCP auto configuration feature. When enabled, the Switch is
Configuration
instructed to receive a configuration file from a TFTP server, which will set the Switch to become
State
a DHCP client automatically on boot-up. To employ this method, the DHCP server must be set
up to deliver the TFTP server IP address and configuration file name information in the DHCP
reply packet. The TFTP server must be up and running and hold the necessary configuration file
stored in its base directory when the request is received from the Switch.
Click Apply to set the DHCP Auto Configuration State.
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 2 - 22. DHCP Auto Configuration Settings window
21