REMOTE SOFTWARE
SET UP A REMOTE CONNECTION
The administrator and up to nineteen additional users (four simultaneously) can access the
DVR remotely using software installed on a personal computer.
Configuring the DVR
1.
Press SETUP on the front of the DVR or remote control to log in.
2.
Select NETWORK > NETWORK SETUP (see the Network Setup section of this manual
for more details).
3.
Change port settings or write down current port settings.
4.
Select DHCP or STATIC IP depending on your network (Ask your network administrator
for assistance).
5.
If STATIC IP is selected - define the IP address and additional network information.
6.
If DHCP is selected - write down the IP address supplied by the DVR system.
Note
7.
Select SAVE to save current settings.
29716AB
If the DVR does not display the IP Address after setting DHCP to ON, Select Save
to change the network and open Network Setup again.
71