Table of Contents
Advertisement
TURNING ON THE DVR
1.
Connect camera cables.
2.
Connect a network cable and a monitor cable.
3.
Connect the power cable to the DVR and wait until the main screen is displayed on the
connected monitor; this process will take approximately two minutes.
Tip
Using the Front Panel to Turn On/Off the DVR
To start the DVR:
•
Press and hold the SETUP key on the front panel of the DVR until the
lights start to flash.
To shutdown the DVR:
•
Press and hold the SETUP key on the front panel of the DVR, log in
when prompted and select OK to shut down.
Note
SETTING THE REMOTE CONTROLLER ID
When more than one E240 DVR is installed in the same location, you can use one remote
controller to control multiple DVRs – up to 20 DVRs. To control multiple DVRs, you must
change the remote controller ID to the DVR ID of the DVR.
To change the remote controller ID:
1.
On the DVR, go to SYSTEM > SYSTEM SETUP.
2.
Enter the desired DVR ID number.
3.
On the remote controller, press and hold the ID button and enter the desired DVR ID
number to operate the corresponding DVR.
Note
29716AB
See the Connection Guide section for more details.
Only authorized users can shut down the DVR.
The DVR ID must be input as two numbers on the remote controller. Therefore you
should input 00 for the system ID 0 and input 01 for 1.
25
Advertisement
Table of Contents
