Installing A Lifesize Room System - LifeSize Room Installation Manual

Installing a LifeSize Room System

To install the components of your LifeSize system, remove all components from the product
packaging, including cables, and place them in the desired positions in your conference
room. Refer to the LifeSize quick reference card included with your system for a visual
depiction of the proper setup. The numbers that appear on the quick reference card
correspond to the following steps:
1. Open the battery compartment on the back side of the remote control.
a. Before inserting the batteries, stretch the two straps across the battery
compartment.
b. Insert the two outer batteries, negative end (-) first against the spring, then press the
positive (+) end into place, trapping the cloth straps beneath the batteries.
c. Lay the longer cloth strap over both batteries and insert the center battery's negative
end against the spring first to trap the longer cloth strap beneath it. Then press the
positive end of the battery into place.
d. Lay the ends of the cloth straps over the center battery and install the cover.
2. Insert the codec into its stand by aligning the pin holes at the base. Secure the codec in
the stand by tightening the bolt on the bottom of the codec stand. Optional: Insert the
rubber feet on the bottom of the codec stand.
Note: When inserting the necessary cables into the back panel of the codec, LifeSize
recommends you route them through the plastic strain relief guide at the bottom of the
unit to keep all cables secure.
3. To connect a LifeSize Camera to the codec, insert the camera cable into the port on the
rear side of the camera and plug the opposite end into the port marked with the camera
1 symbol on the back panel of the codec.
If you purchased a second LifeSize Camera for use with LifeSize Room, insert the
camera cable for the second camera into the port on the rear side of the camera and
plug the opposite end into the port marked with the camera 2 symbol
panel of the codec. For more information about using two cameras with your LifeSize
Room system, refer to your LifeSize Video Communications Systems User Guide.
To connect a supported third-party camera using a LifeSize SDI Adapter, refer to the
LifeSize SDI Adapter Installation Guide.
10 LifeSize Room Installation Guide
on the back