Table of Contents
Advertisement
Configuring Display Output from LifeSize Phone
If the initial configuration screen appears distorted and unusable or the attached display is
blank, you must configure your display from the administrator interface on the LifeSize
Phone.
To resolve problems with monitors from the LifeSize Phone interface, follow these steps:
1. Ensure that no calls are in progress.
2. Log in to the Admin Menu on your LifeSize Phone.
a. Press
b. Enter the administrator password (1 2 3 4 by default) and press
3. Press 1 on the keypad to select Preferences.
4. Press 1 on the keypad to select Display 1.
5. Press the
select VGA for the Display Type to manually set the display to VGA. If your display
supports both 1280x720 and 1280x768, you can manually configure the system to use
one of these resolutions by setting the Display Resolution preference.)
6. Press the
Note:
If you remain idle on any preference screen for two minutes, you return to the
main screen.
7. When you have finished setting preferences, press the
8. Press
to return to the previous screen.
18
sequentially when the phone is idle.
key to select Auto. (If you are resolving problems with a VGA monitor,
key again to accept your change(s).
.
key to save them.
LifeSize Room Installation Guide
Advertisement
Table of Contents
