Connecting A Pstn Phone Line; Locking The Lifesize Codec - LifeSize Room 200 Installation Manual

Hide thumbs Also See for Room 200:

Installation manual (24 pages)

Table Of Contents

Table of Contents

7. Insert the cord from the power adapter into the power outlet marked

the back of the codec (near the base). Insert one end of the power cord into the power

adapter and the opposite end into a power outlet on the wall.

The LifeSize system starts and illuminates a blue LED on the front of the codec. See

"Status Icons" on page 26 for more information about the state of the system as it boots

or as conditions change.

The camera initializes the first time it is connected to a codec; this process takes

approximately 90 seconds.

Warning:

Do not disturb or disconnect the devices during this time as you may

damage the system.

8. An Initial Configuration screen appears and prompts you to configure the system.

Refer to "Initial Configuration" on page 6 and the information you collected there

previously to guide you through your configuration choices. Use the arrow keys on the

remote control to navigate the preferences that appear in the initial configuration

screens. Icons that appear at the bottom of each screen correspond to keys on the

remote control and indicate what operations are available for the screen or a selected

object.

If the initial configuration screen does not appear and the display is blank, refer to

"Troubleshooting Installation Issues" on page 23.

The bottom of the screen contains the system status bar and the navigation bar. The

system status bar indicates system and network status. When the system is booting,

status also appears at the top of the REDIAL list to indicate the current state of the

system. See "Status Icons" on page 26 for an explanation of status icons you may

encounter.