Installing Your System - LifeSize Icon 800 Installation Manual

Installing the System Into a Rack
After you have the rack mounting brackets in the correct position, install the system into the rack.
1. Line up the system in the desired position on the rack.
NOTE
Ensure that sufficient access is provided to the serial port to allow connection
for setup and servicing.
2. Attach the rack mounting brackets on the system to the rack using the appropriate hardware for your
rack (not included).

Installing Your System

Before you install your system, read the Lifesize Safety and Regulatory Notices for important safety
information.
WARNING
Exercise care when connecting cables to the codec. Face the back of the
codec or ensure that all connectors are visible when connecting a cable to
the codec.
To install your Lifesize system, remove all components from the product packaging and place them in the
appropriate positions in your conference room or office.
WARNING Do not place objects that can generate heat or obstruct airflow in front of,
on top of, or behind a codec. Such placement can cause the system to
overheat and restart. Further, prolonged overheating can damage the
codec. Make sure the room that houses the codec features a controlled
temperature and is well ventilated.
1. Open the battery compartment on the remote control by sliding the bottom end toward the back side of
the remote. Insert two AAA batteries:
To close the battery compartment, align the cover with the rails on the remote and slide in place.
Lifesize Icon Installation Guide
5