MUTOH Valuevet VJ-1324 Operation Manual page 97

VJ-1324 OPERATION MANUAL
4. Check the both ends and the center of the print result that printed with Adjust pattern, and select the
number from 1 to 7 that is not out of alignment.
• "6" is selected in the next printing sample.
NOTE
• "4" is the current setting value.
5. "Pattern *: 4" (* indicates a pattern name as shown below) is displayed on the operation panel.
• The pattern name (*) differs depending on the set print mode.
The print modes and their pattern names are as follows.
PrintMode
Quality 1, 2
Quality 3, 4
Graphics 1, 2
Graphics 3, 4
Banner 1, 2
Banner 3, 4
6. Press the [+] key or [–] key to enter the number that you selected in Step 4.
NOTE
• When you press the [Cancel] key, the input operation is not executed and "Adj.3: Fine Pattern" is
displayed on the operation panel.
3.6 Adjust Print
PatternName
C
B
E
D
A
A
Before using
97