VJ-1324 OPERATION MANUAL
5.1.7
Method of Cut menu
Sets the media cutting operation after printing.
NOTE
• When the the media detection is set to "Off", the media cannot be cut automatically.
• Some media may not be cut (cannot be cut at all or cannot be cut finely). In such a case, set the
"Output Mode menu" to "Off" and cut the media manually.
5.1.6 Output Mode menu
4.4.4 Cutting media manually
• The cutting direction is different depending on the firmware version.
Setup item
Method of Cut
5.1.7.1
Cut Pressure menu
Sets the media cutting pressure for the cutting operation.
Setup item
Cut Pressure
5.1 Setup menu
Setting
SingleCut-2 steps
<SingleCut-3 steps>
DoubleCut-2 steps
DoubleCut-3 steps
—
Setting
Low
<High>
-
Description
Cuts at a shorter process than SingleCut-3 steps method.
Suitable for media with a narrow width.
Normal cutting method.
Set when the media is not cut with SingleCut-2 steps method.
Suitable for media with a narrow width.
Set when the media is not cut with SingleCut-3 steps method.
• [Enter] key: saves the setting and shifts to the previous
menu.
5.1.7.1 Cut Pressure menu
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1 Setup menu
Description
Cut the media at low pressure.
Suitable for thin media or if the "High" pressure setting is
too strong.
Normal cutting pressure
[Enter] key: saves the setting and return to the previous
menu.
[Cancel] Key: Cancel the set value, and return to the
previous menu.
5.1.7 Method of Cut menu
Panel setup menu
179