MUTOH Valuevet VJ-1324 Operation Manual page 164

Panel setup menu
5.1.1.1.2 Effect menu
Sets up the Effect menu.
Set up this menu when you want to improve print quality by adjusting the set Print Mode.
NOTE
• The print quality may not be improved depending on the printing condition.
Setup item
Effect
*1 The default value of the effect differs depending on the selected print mode as shown below.
164
Setting
<None> *1
Wave
<Fog> *1
<Fine & Fuzz> *1
<Fine & Fog> *1
A-S.Fine & Wave
B-S.Fine & Wave
—
VJ-1324 OPERATION MANUAL
Description
The Effect function is not used.
The printing joint will be the wave form.
The print quality may be improved than None.
The printing joint will shade off.
Set up this menu when obvious white lines or uneven print
density appear on printed media in "Wave".
Mode for low resolution (360 x 720dpi).
The printing joint will shade off as the wave form.
Perform the printing at slower speed than "Wave".
The printing joint will shade off.
Set up this menu to improve horizontal banding with Fine &
Fuzz.
Perform the printing at a slower speed than Fine & Fuzz.
Performs "Wave" printing using the half of the print head
nozzles.
Since only half of the print head nozzles are used, printing
speed becomes a half of "Wave".
Set up this menu to improve the print quality compared with
"Fine & Fuzz". If used when one side of the nozzles are
clogged, quality deterioration may be avoided.
Performs "Wave" printing using the half of the print head
nozzles on the opposite side of "A-S.Fine & Wave".
Since only half of the print head nozzles are used, printing
speed becomes a half of Wave.
Set up this menu to improve the print quality compared with
"Fine & Fuzz". If used when one side of the nozzles are
clogged, quality deterioration may be avoided.
• [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1 Setup menu
5.1 Setup menu