Introduction; Pc Configuration - Symmetricom GoWide 4.6 User Manual

S S S S S S S

Introduction

PC Configuration

Figure 54. TCP/IP Properties Screen
5
88
S S S S S S S S S
This chapter provides information on configuring the GoWide 4.6 in Gateway mode.
Note:
Ensure that an Ethernet card is installed in the PC.
Note:
The figures illustrating PC configuration are Windows 98 screen captures.
For Windows 95/NT 4.0/2000/XP, please refer to the appropriate user manual.
To configure a PC to communicate with the GoWide 4.6, do the following:
1. Establish a TCP/IP connection to the GoWide device. This is done by clicking the
Start button and selecting Settings, Control Panel, and Network.
2. Click the Network Configuration tab, select the TCP/IP protocol, and click OK
(Figure 54).
3. In the TCP/IP Properties page, enter the Gateway IP address. See Figure 55.
S S S S S S S S S S S S S S S S S S
GoWide 4.6 G.shdsl Bridge/Router – User Manual
Gateway Mode Configuration
097-91022-01 Issue 1: February 2002
S S S S S S